Engineering

Triple P Engineering Team provides multi-discipline engineering services with advanced capabilities of Consultancy.

Process Engineering

• Process Simulation studies.
• Steady state flow assurance.
• PFD / P&ID development.
• Line Designation List (LDT).
• Heat & Material Balance.
• Tie-In Schedules.
• Cause & Effect diagrams.
• Operation, isolation & control philosophies.
• Start-up/down, relief, blow down.
• Flare systems.

Structural & Civil

• Structural optimization.
• Offshore topside Design.
• Weight Control & Optimization.
• Onshore plant structures.
• Pipe racks and Pipe ways/ sleepers.
• Foundation design.
• Brown-field modification

Mechanical & Material

• Packaged equipment.
• Static equipment design (pressure vessels & Tanks).
• Rotating equipment (selection).
• Vendor selection, requisitions, technical bid evaluations.
• Materials selection reports.
• Painting, Coating, Insulation and Cathodic protection.
• Valve and piping specification

Technical Safety & Loss prevention

• Fire and Gas layouts.
• Hazard area drawings & schedules.
• QRA.
• SIL assessment and classification.
• Consequence analysis.
• Blast & explosion analysis.
•HAZID & HAZOP chairing

Electrical & Instrument

• Power generation systems – gas turbine and Diesel generators.
• Power system analysis and studies MV and LV.
• Single line diagram
• Power factor improvement.
• Voltage drop
• Protection relay co-ordination
• Earthing / lightning systems
• Motor sizing, selection, power consumption and starting calculations.
• Emergency power systems design
• Hazardous area equipment selection and specification.
• Control & Instrumentation system specification.
• PLC , SCADA and BMS design
• Wiring digram, I/O lists
• Low current systems design ( PABX, IP systems, CCTV
• Cable sizing and Raceways design Load flow
• Short circuit
• Panels selection / specifications
• Lighting design in-door/out-door

Piping / Pipeline & Layout.

• Plant 3D modeling & layout.
• Development of Plot Plans and Equipment layouts.
• Clash detection & resolution.
• Layout optimization.
• Piping material Specification.
• Pipe stress analysis CAESAR II (Static & Dynamic).
• Piping supports design.
• Isometrics and Bill of Materials (BOM-MTO-BOQ).
• Piping General Arrangements (GA).
• Onshore pipeline calculations & alignment sheets.

Offshore Structure & Sub-sea

• Assessment and push over analysis
• Topside weight control analysis, and modifications
• Pile capacity re-evaluation
• Spud can checks
• Sub sea installation and foundation systems
• Sub sea pipe lines stress analysis
• Foundation of vibrating equipment’s
• On shore pipe racks and steel structures
• Blast proof building analysis
• Offshore Hull Tanks and Sloshing analysis
• Fixed offshore analysis ( In-place, Dynamics,
Fatigue, Installation)
• Floaters, Hulls, and Jack-Up rigs

This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.